Fluke LinkRunner AT 1000, Руководство пользователя

Страница: 30 / 36

LinkRunner AT 1000/2000 Network Auto-Tester
Users Manual
22
Using PoE Feature
PoE is disabled by default. To enable PoE, select
Tools > PoE
Configuration
, and check
Enable PoE
. Select the Class
you want to verify. If you have purchased the LR-AT 2000,
you can TruePower
TM
test the Class. The results are displayed
in the Autotest and Switch tests.
When you select a PoE Class higher than the switch can
handle, LR-AT 2000 will provide the loaded results
indicating the switch can not handle this Class setting. The
LR-AT 1000 will display the unloaded results indicating
voltage and wattage selected.
The following example was tested on a Class 3 (13w) switch.
The tester PoE configuration was set to Class 4 (25w) with
TruePower
TM
disabled.
Figure 19 displays the AutoTest results and Figure 20
displays the Switch results. Notice in the Autotest results,
the wire pair polarity, wattage requested and wattage
received, voltage and PSE type are given.
PSE is the Power Sourcing Equipment rating, Type 1
(12.95W - 15.40W) and Type 2 (25.5W - 34.20W).
ffy37.bmp
Figure 19. TruePower
TM
Disabled PoE AutoTest Results
In the next example, the Switch results are shown with the
same setup, i.e., no load, Class 4 (25.5w).
ffy39.bmp
Figure 20. TruePower
TM
Disabled PoE Switch Results