Fluke Hart Scientific 1523, Техническое руководство

Страница: 96 / 110

1523, 1524 Reference Thermometer
Manual Calibration Process
88
5HFRUGWKHGDWD
Note: Steps 66 through 70 apply to the 1524 only. Proceed to step 71 if using a 1523.
66. (1524 ONLY) Set Channel T2 of the UUT in the HI_OHMS cal range by
sending the following commands through the serial port:
&$/'(95$1*6(/+,B2+06
67. Turn off T1 by sending the following command.
&$/'(95$1*(6(/1250$/
'LVFRQQHFWUHVLVWRU
68. Connect a 100K Ohm resistor to the calibration cable connected to the UUT on
Channel T2.
69. Query the reading every 2 seconds for 40 readings using the following
command:
0($6"
5HFRUGWKHGDWD
70. Turn off Channel T2 by sending the serial command:
&$/'(95$1*6(/1250$/
&RQQHFWWKHFDOLEUDWLRQFDEOHWR&KDQQHO7
7.9.1.3.5 Millivolt Range
71. Set the UUT in the mV cal range by sending the following commands through
the serial port:
&$/'(95$1*6(/09
72. Connect the voltage source to the calibration cable as described in the
Preparation & Settings for Reference readout Calibration section.
73. Set the output of the voltage source to -10 mV.
74. Query the reading every 2 seconds for 40 readings using the following
command:
0($6"
5HFRUGWKHGDWD
75. Set the output of the voltage source to 0 mV.
76. Query the reading every 2 seconds for 40 readings using the following
command:
0($6"
5HFRUGWKHGDWD
77. Set the output of the voltage source to 25 mV.
78. Query the reading every 2 seconds for 40 readings using the following
command:
0($6"
5HFRUGWKHGDWD