15
Inspect an Endface
Insert the probe tip into a bulkhead connector, or into an
adapter attached to a patch cord (Figure 8).
The app shows a live image of the endface. You can adjust the
image as shown in Figure 9.
Press
to focus the image if necessary, then press
or tap
Test
on your mobile device.
3.
When the LEDs on the probe show the pass ( ) or fail ( )
result, you can remove the probe from the connector.
4.
After the probe transmits the test results to your device, the
app shows the
TEST RESULT SUMMARY
screen. You can then
Save
or
the result or tap the endface graphic to see
detailed results. See “Endface Image Screens” on page 17.
To see the live image again, tap or
Live
.
CL04.PDF
Inspect an Endface
Adapter*
Patch cord
* The adapter’s key position affects the fiber numbers
in your test results. See “Set the Key Position” on
page 13.
www.
.com
1.800.561.8187
