S
Access low level set-point value
L= -100
Adjust the low level se-point
U
Increment the low level set-point
L=- 50
New low level set-point
When the desired low level set-point value is reached, press “SET” to accept
the new value and access the decimal place setting.
S
7.11.2
DP (Decimal Place)
DP allows the user to set the decimal place on the display for one or two deci-
mal places. DP defaults to two places.
dP
Decimal place setting
Press “SET” and then “UP” or “DOWN” to change the decimal place setting or
press “EXIT” to return to the beginning of the “
PAR
” menu.
S
Access decimal place setting
dP = 2
Adjust decimal place setting
D
Decrement the decimal place setting
dP = 1
New decimal place setting
Press “SET” to accept the new decimal place setting.
S
7.12
Serial Interface Parameters
The serial RS-232 interface parameters menu is indicated by,
SErIAL
Serial RS-232 interface parameters menu
The serial interface parameters menu contains parameters which determine the
operation of the serial interface. These controls only apply to controllers fitted
with the serial interface. The parameters in the menu are — BAUD rate, sample
period, duplex mode, and linefeed.
2200 Temperature Controller
User’s Guide
32
