Fluidwell F030-A, Руководство пользователя

Страница: 7 / 56

Page 7
FW-F030-P-M_v0404_01_EN.docx
2 OPERATIONAL
2.1 GENERAL INFORMATION
This chapter describes the daily use of the F030-P. This instruction is meant for users / operators.
•
The F030-P may only be operated by personnel who are authorized and trained by the
operator of the facility. All instructions in this manual are to be observed
•
Take careful notice of the "Safety rules, instructions and precautionary measures" in the
front of this manual.
2.2 CONTROL PANEL
The control panel has three keys. The following keys are available:
Fig. 2: Control panel.
Functions of the keys
PROG -key
This key is used to program and save a new value for PRESET and to clear total when
it is shown on the display.
The PROG-key is also used to gain access to SETUP-level; please read chapter 3.
START -key
This key is used to START the batch process or continue the batch process after it has
been paused.
The START-key is also used to increase a digit after the PROG-key has been pressed;
please read chapter 3.
STOP -key
This key is used to PAUSE the batch process (which can then be continued via the
START-key), and after that to STOP the batch process (which cannot be continued).
When the batch process is stopped, the STOP-key is used to select total and
accumulated total.
The STOP-key is also used to select the next digit after the PROG-key has been
pressed; please read chapter 3.
2.3 OPERATOR INFORMATION AND FUNCTIONS
In general, the F030-P will always function at Operator level. The information displayed is dependent
upon the SETUP-settings. The signal from the connected sensor is processed by the F030-P in the
background, whichever screen refresh rate setting is chosen. After pressing a key, the display will be
updated very quickly during a 30 second period, after which it will slow-down again.
For the Operator, the following functions are available:
•
To enter a batch quantity
To change the PRESET-value, following procedure must be followed:
1) when ACTUAL and PRESET are shown, press PROG: the word "PROGRAM" will be flashing,
2) use

to select the digits and

to increase that value,
3) set the new PRESET-value by pressing ENTER.
When data is altered but ENTER has not been pressed yet, then the alteration can still be
cancelled by waiting for 20 seconds or by pressing ENTER during three seconds: the former
value will be reinstated. The PRESET-value can be used time after time till a new value is
programmed.
Please note that alterations will only be set after ENTER has been pressed!.