/ 9 /
INSTALLING THE BACKPLATE
Take enclosed mounting screws and install them as shown on picture below.
Use six (M2.5x4 AX1) screws, and tighten them using Philips head screwdriver.
Screw M2,5x4 AX1
INSTALLING THE FITTINGS AND TUBING
Plug G1/4
Plug G1/4
Compression fitting
Screw in the two G1/4 threaded male fitting. Attach the liquid cooling tubes and
connect the water-block(s) into the cooling circuit. On other two G1/4 openings
attach the enclosed plugs.
You can use any opening as an inlet/outlet port.
In case of using connectors other than EK-ALU series compression
fittings, take special attention to the length of the fittings male G1/4
thread. 5mm is the maximum allowed G1/4 thread length!
