Flowserve NRS 1-7, Руководство по установке

Страница: 34 / 40

4
Wiring
NRS 17
Cable required for wiring to the electrode: fourcore screened cable, e. g. IY(St)Y x x 0.8 or
LIYCY 4 x 0.5².
Max. cable length 00 m with a conductivity from 0 µS/cm.
Max. cable length 0 m with a conductivity from 0.5 µS/cm.
Max. cable length 5 m with a conductivity from 0.5 µS/cm when used in conjunction with inverter
URN (4 V d. c.)
Tools

Screwdriver for slotted screws, size .5, completely insulated according to VDE 0680.
Voltage table
Use this voltage table as reference when checking the level electrode for malfunction or submersion.
Take the wiring diagram (see Fig. 10, Fig. 11 ) into account.
U

U

⊥
U

⊥
Submerged Exposed Malfunction (submerged/alarm)
0 V
eff
0.5 µS/cm,
C = 0. cm

V
eff
0 µS/cm,
C = 0. cm

<
U

2
≥
U

2
≤
U

⊥
Attention

To protect the switching contacts provide the circuit with a .5 A slowblow fuse or
according to TRD regulations (.0 A for 7 hrs operation).

The screen must not make any other electrical contact.
Note

The selfchecking routine of the NRS 7 reduces U

⊥
every 40 sec. considerably,
even down to 0 volt.

Connect screen only to terminal 8 of the level switch.

The sensitivity is indicated on the name plate.

The rated voltage is indicated on the name plate.

When switching off inductive loads, voltage spikes are produced that may impair
the operation of control and measuring systems. Inductive loads should therefore be
provided with commercial arc suppressor RC combinations, e. g. 0. µF / 00 Ω.
EN