Flowserve IPS Wireless SELD-102, Инструкция пользователя

Страница: 6 / 22

IPS WIRELESS SELD-102 Node ENGLISH 702-3001 07-17
Page 6 of 22
flowserve.com
removed and disposed of in accordance with
current local regulations.
2.5 Disposal instructions
At the end of the product’s life, do not
dispose of any electronic component or instrument
in the domestic waste. Disposal should be done in
accordance with applicable regulations, which vary
from state to state and country to country.
Battery Disposal Instructions: Disposal should
be done in accordance with applicable regulations,
which vary from country to country. Batteries
should not be incinerated, unless suitable
procedures are followed and qualified handlers
have taken appropriate precautions. Exposure of
these cells to high temperatures or fire can cause
the cells to vent and/or rupture. These cells do not
contain dangerous substances. The reaction
products are inorganic and do not represent
environmental hazards, once the decomposition or
neutralization process has terminated.
Disposal in Europe
Batteries for disposal should not be transported by
air. For road transport of dangerous goods ADR
special provision 636 and packing instruction 903a
apply.
Disposal in US
Hazardous waste of spent batteries can be disposed
after they are first neutralized through an approved
secondary treatment prior to disposal. Disposal of
spent batteries should be performed by authorized,
professional disposal company, which has the
knowledge in the requirements of the Federal, the
State and the Local authorities regarding hazardous
materials, transportation and waste disposal. In
any case it is recommended to contact the local
EPA office.
Proper shipping name: Waste lithium Batteries
UN Number:
3090
Label requirements:
Miscellaneous, Hazardous
Waste
Disposal Code:
D003
3 DESCRIPTION
The SELD-102 Node-X (
where “X” designates a
specific hardware configuration per order) model is
a wireless transmitting unit designed to monitor one
single (or combination) sensor input and wirelessly
transmit the data to a receiver. The SELD-102
Node also provides two LED indicator lights for a
quick visualization of equipment health. (See 6.5
LED Indications)
The SELD-102 Node is a self-powered unit that can
either have a built-in sensor or interface to an
external sensor (configuration options are detailed
in the Options section). The SELD-102 Node
includes an encapsulated battery pack, main board
and transmitter card housed inside a non-metallic
tube with a 316 SS base insert. Each unit also has
a single diagnostics port (on the top of the main
board inside the unit) for programming and
troubleshooting the unit.
Figure 1: Bottom of SELD-102 Node unit
The SELD-102 Node model has a built-in omni-
directional wireless antenna, allowing for reliable
signal transmission. Each unit is configured to
wirelessly transmit data over one of the 900MHz or
868MHz spread spectrum frequencies (frequency
is factory set). Data transmittal can occur at a
customizable time interval, ranging from every 5
seconds to once a day (this time interval is usually
pre-configured at the factory). Transmission rates
can also be varied according to sensor signal
values (see section 5 CUSTOM
CONFIGURATION PROGRAMMING), thereby
prolonging battery life. The SELD-102 Node unit
has a maximum data transmittal range of ¾ mile
(1.2km) under ideal conditions, but its effective
transmission range can be extended using a
network of repeaters.
Each SELD-102 Node is a part of a larger wireless
monitoring network. As such, each unit comes with
a calibration sheet from the factory which contains
unit-specific configuration information describing
the sensor(s) and wireless network the unit is
configured for (parameters such as the wireless
Sensor Process
Input Connection