FLORIDA-PNEUMATIC.COM
Please contact 1-800-356-3392 for further assistance.
Operation
1
Operating the angle die grinder
□
This Angle Die Grinder is designed to operate on 90 PSIG.
Lower pressure (below 90 PSIG) will reduce performance
of the tool. Higher air pressure (over 90 PSIG) raises the
performance of the tool beyond its rated capacity and
could cause serious damage to the tool and the user.
2
Installing the grinding stone
WARNING:
Disconnect the tool from the air supply before
servicing or changing accessories.
WARNING:
Always use ANSI approved grinding stones
with the rated tool RPM.
□
Loosen the collet nut with the spanner wrench.
□
Insert the grinding stone in the collet. If using a 1/8 in. collet
stone, an adapter (not included) must be inserted before
placing the stone into the tool.
□
Tighten the collet nut with the spanner wrench.
3
Removing the grinding stone
WARNING:
Disconnect the tool from the air supply before
servicing or changing accessories.
□
Loosen the collet nut with the spanner wrench.
□
Pull the grinding stone out and tighten the collet nut with the
spanner wrench.
4
Grinding and deburring
WARNING:
You must wear the ANSI approved eye
protection during the operation; failure to follow this this may
result in serious injury or damage to the operator.
WARNING:
Hearing protection is strongly recommended. A
Protective respirator is recommended.
□
Connect the die grinder to the air supply.
□
This tool features the safety lock-off mechanism.
□
Operate the tool by disengaging the lock-off mechanism
and depressing the throttle lever to run the tool for grinding
or deburring.
