Floria garden products SNGH-A1, Руководство по сборке

Страница: 2 / 20

Dear Customer!
May we congratulate you on your new Greenhouse.
We feel sure that by following the detailed assembly
instructions you will find as much pleasure in actually
building the greenhouse as the time you will spend in your
greenhouse in the future.
The assembly instructions mainly consist of detailed
illustrations and no specific technical knowledge is required
for the assembly of the greenhouse.
Precautions
•Always try to select a sunny location, sheltered from the
wind as much as possible. Assembly must only be carried
out in dry and calm weather.
• Always use working gloves while handling aluminum
profiles and polycarbonate.
• Place the ladder on a level support.
• It is essential to have an assistant.
Tools
• Spirit level;
• Spanner or wrench 8 mm, screw driver normal and
crosshead PH2;
• Electric drill.
Winter Protection
• Support the roof ridge at the centre of the greenhouse.
• Remove greater snow loads from the roof.
• Take precautions against snow falling down from trees or
a house roof.
• Dismount the cylinders for the automatic window
openers, if any (optional extras).
• Secure doors and windows preventing wind damage to
the greenhouse.
Complaints
We put severe demands on quality to secure that you get a
faultless product. However, should a problem occur, we
kindly ask you to contact the dealer from whom you have
bought the greenhouse. For a quick service, you should
specify the defect by means of the parts list in the assembly
instructions. Please also note the model number which is
stamped on the front page of these instructions.
Guarantee
Manufacturer gives frame guarantee which covers
replacement or repairs of defective parts due to material or
manufacturing fault. Moving and painted parts, glazing and
damage caused by wind or other extreme weather
conditions are excluded.
The guarantee does not cover, assembly, freight etc. The
guarantee is invalid if the greenhouse is not assembled
according to these instructions.
Insurance
Please note that not all insurance companies cover
greenhouses automatically. Please contact your insurance
company to ensure an insurance coverage.
Tips
1. The base anchors has to be fastened/concreted into the
ground.
2. The base has to be 100% level and square. The easiest way
to ensure this is to make sure that the two diagonal
measurements are equal.
3. We recommend that you grease screws for doors and
windows for easier assembly.
4. If desired, it is possible to seal the greenhouse at the edges
and conners, also gap between polycarbonate and gutter,
using neutral silicon.
5.
Polycarbonate —the UV-protected side (outside) of the
sheet is covered with transparent film and must be faced
towards the sun. Remove approximately 2 inches of film from
all sheet edges before installing. Remove all film immediately
after the constructions is completed. Polycar-bonate plates
must not come into contact with the ground. Always rest
them on cardboard or similar material during construction.
Maintenance
• Grease doors (hinges and lock or door track).
• Clean the gutter for leaves, etc.
• Adjust windows and doors.
• Clean the greenhouse before and after the growing season.
Use only gentle detergents and soft cloth (please check first if
the detergent does not react aggressively with the aluminum
profiles and polycarbonate).