FLORABEST FGs 72 a1, Оригинальное руководство по эксплуатации, Страница: 13 / 84

13
GB
and screw them together using
the height adjustment screw (17)
.
Ensure that the mains cable is not
caught.
Assembling the rollers:
2. Remove one roller (20) from the
axle.
3. Push the axle through the holes on
the telescopic shaft and reconnect
the rollers and axle (20).
Assembling/dismantling the
telescopic shaft
1. Push the equipment into the tel-
escopic shaft equipment holder
(19). It clicks audibly into place.
2. Plug the plug connection (16) into
the charging socket (5) on the
back of the equipment handle (3).
3. To dismantle, release the plug con-
nection (16) and pull the equip -
ment out of the telescopic shaft
equipment holder (19).
Operation
Keep to noise abatement regulations
and other by-laws.
Switching on and off
1. Remove the blade guard (
8/10) before switching the unit
on.
2. - To switch on, hold the off-lock
switch (2) depressed and
operate the on/off switch
(6). Then release the off-lock
switch.
- To switch on the equipment
when using the telescopic
shaft, operate the off-lock
switch (12) and on/off switch
(14) on the telescopic shaft.
The equipment runs at top
speed.
3. In order to switch off, let go of
the on/off switch (6/14).
When using the telescopic shaft, the unit
can only be switched on and off at the
shaft handle.
After switching the unit
off, the blades take a short
time to stop moving. Let the
blades come to a complete
standstill. Do not touch the
moving blades and do not
try to stop them moving. In-
jury hazard!
General working instructions
While trimming, take care that
there are no objects such as wire,
metal parts, stones etc. come into
contact with the blades. This can
lead to cutting head damage. If the
blades become blocked by solid
objects, switch off the unit at once.
• Check the grass and bush trimmer
blades for obvious defects such as
loose, worn or damaged parts. Check
that the screws are seated firmly in the
blade block.
• Remove the power supply unit before
working with the equipment. Do not
use extension cables. The power sup-
ply unit is to be used only in enclosed
spaces.
• Only use sharp blades to achieve a
good cutting performance and pre-
serve the battery.