SATELLITE 970-6 MkII
1800 FLOOREX
1800 356 673
PAGE
4.
OPERATING INSTRUCTIONS
1.
Wear clothes suitable for the job and for the work place including,
safety shoes, hard hat, hearing protection, non-fogging vented
safety goggles, and dust respirator suitable for dust.
2.
WARNING!
POISONOUS EXHAUST GASES. Do not operate
petrol powered equipment without adequate ventilation. Carbon
monoxide is an invisible odorless gas that can harm or can kill you.
3.
Be sure all equipment is tested and tagged prior to use on any job.
4.
Inspect entire area to be ground before grinding and remove any
bolts or concrete nails (etc) that could damage diamond tooling or
machine which could cause a hazardous situation.
5.
Ensure there are no obstacles or existing structures that could
present a hazard to the operator. If so, take necessary action to
eliminate the hazard.
6.
Fold handle into upright position (See
‘storage & diamond removal’,
following page) then tilt machine back so handle is resting on the
floor. (See figure 1c).
7.
The machine takes a set of six (6) tools. Be sure the tools are of
even height.
8.
Install appropriate diamond tooling or other available tooling into the
machine. Only use genuine SATELLITE tooling. Failure to comply
could result in bodily injury.
9.
Tilt machine back onto the disk and unfold handle. (See operation
mode previous page)