floorex Meteor 250 MkII, Руководство оператора

Страница: 6 / 28

Meteor 250 MkII
1800 356 673
5.
1800 - FLOOREX
Operating instructions
1. Wear clothes suitable for the job and for the work place including, safety
shoes, hard hat, hearing protection, non-fogging vented safety goggles,
and dust respirator suitable for dust.
2. WARNING! POISONOUS EXHAUST GASES. Do not operate petrol
powered equipment without adequate ventilation. Carbon monoxide is an
invisible odorless gas that can harm or can kill you.
3. Be sure all equipment is tested and tagged prior to use on any job.
4. Inspect entire area to be ground before grinding and remove any bolts
or concrete nails (etc.) that could damage diamond tooling or machine
which could cause a hazardous situation.
5. Ensure there are no obstacles or existing structures that could present a
hazard to the operator. If so, take necessary action to eliminate the
hazard.
6. To change the Disk; Fold handle into the tooling mode (see Handle
Positions ) and lock in place using the locking lever, then tilt machine
back so handle is resting on the floor.
7. The blade is removed by pushing the lock button located on the right
side of the machine on the stainless steel shroud, shown on following
page. (Do not engage this button when shaft is still rotating).
8. Install appropriate diamond tooling or other available tooling into the
machine. Only use genuine METEOR 250 MKII tooling. Failure to comply
could result in bodily injury.
9. Tooling fitted to this machine must not exceed 30mm high from Face of
segment to the face against the machine boss. Floorex does not warrant
the machine against damage resulting from after-market tooling.
10. Tilt machine back onto the disk and lock handle into the best position in
the operate mode for the operator comfort. (See
Handle Positions )