Flonidan Uniflo 1200 GVEC, Руководство пользователя

Страница: 6 / 15

U:\Hovedbibliotek\Produkter\Standard\Uniflo 1200\2. Kundemappe UK\8_Option
Board_Communication\8.1_communicatiom_controller\Communication_board_230210.doc
Page 6 of 15
Communication_board_230210.doc
Communication board connected directly to PSTN modem
Settings: Output
standard: Optical (default)
Protocol: Modbus RTU (default)
Baud rate: 4800 (default)
Data format: 8-N-1 (default)
Connection type: PSTN modem
Mode: MASTER
Communication board connected via bus to PSTN modem
Settings: Output
standard: Optical (default)
Protocol: Modbus RTU (default)
Baud rate: 4800 (default)
Data format: 8-N-1 (default)
Connection type: PSTN modem
Mode: SLAVE
3.1 GSM modem
GSM modem may be used for conventional dial up (or dial back in case of alarm) and/or using SMS for
alarm message and recorded measuring values.
It's only possible to select either a dial back or a SMS transmission in case of an alarm.
GSM dial back in case of alarms
When an alarm is marked with "1: Dial" or "0: Dial" in the Alarm set up page and the alarm occurs/disappears
a GSM dial back to "Primary phone no" is started. When connection is established the content of the "ID-
string" is transmitted to the receiving application. Hereafter the communication board will change to Modbus
RTU mode and communication can begin.
If the call doesn't succeed the communication controller will retry 10 times on the "Primary phone no" and
then switch to "Secondary phone no" for another 10 retries.
The following settings are required to make a GSM dial back:
Primary phone no.: Phone no. for host computer receiving alarm calls.
Secondary phone no.:
Phone no. to use, if primary phone no. is not responding (after having tried 10
times)
ID-string:
Enter Uniflo ID-no. to send to host computer
Send ID:
Must be marked.
GSM – SMS in case of alarms
When an alarm is marked with "1: Dial" or "0: Dial" in the Alarm set up page and the alarm occurs/disappears
a SMS is transmitted to "Primary phone no". The SMS contains the "ID string" and alarm status.
The following settings are required to make a GSM-SMS alarm transmission:
Primary phone no.:
Phone no. for host computer or cellular phone receiving alarm SMS, country
code is optional but if included it must be preceded by a “+”.
Secondary phone no.: Not used.
ID-string:
Enter a unique ID for the unit.
Send ID: Must NOT be marked.