G4SZV-1/G4SZV-2 & G4SDZV-2 V1.10
Page 24
2.8.3
Input methods using Push Buttons
2.8.3.01
Enter UTRN
Select PREPAYMENT from the Main Menu structure
Select NEW payment from the next level down
The display will now show:
A B C
Where the first digit is ENLARGED as shown
You can now use middle button (B) to move the cursor (enlarged digit) along to the
right (note it will cycle around when you get to the end (RHS)
For each highlighted digit, you can use the left hand button (A) to cycle from 0 to 9
Using these 2 buttons you can enter the UTRN
While entering an UTRN the right-hand button will show the MENU symbol, you
can use this to exit without changing anything ( ie no entry)
When you reach the RHS end digit (ie the last of the 20 digits) the Menu symbol
will be replaced by the “return” symbol, at this point if all the digits are correct, you
can enter the UTRN by pressing button C (RHS).
Until you press this, you can go back and correct any false entries in the 20 digit
code. And then go to the RHS to enter the UTRN
2.8.3.02
Enter PIN
When entering a PIN code, the same method is used, except there are only 4 digits
A B C
Enter UTRN
0
0000000000000000000
Enter PIN Code:
0
000
