Flo Fab 880RI Series, Руководство по эксплуатации, обслуживанию и установке

Страница: 7 / 41

SINCE 1981
6
GENERAL CARE
Each plate has a gasket that produces a sealing and channel system through the entire plate
pack in which the two heat exchanging media flow in a counter-current direction.
The circular portion of the gasket stops the fluid from going across the heat transfer plate and
sends it to the next open channel. The remaining portion or field gasket, directs the opposing
fluid across the heat transfer surface.
The gasket can be mechanically clipped to the plate with the glue free “U” shaped clip or glued
in place.
1 . Keep unit clean.
2. Avoid excessive belt tension.
3. Provide the motor with adequate overload protection.
4. Keep flying chips or other loose particles away from the ventilating openings of
the motor.
5. Avoid operating the unit in overheated surroundings.
6. Guard three phase motor against single phasing which is frequently accompa-
nied by an unusual humming soud, a drop in speed, and by excessive heating
which, if continued, may burn out the motor windings.
7. Use thermometers when checking temperatures.
8 If pump is standing idle in freezing weather, pump casing and piping should be
drained.
MAINTENANCE
1. LIFE LUBRICATED BEARINGS are heavy duty permanently lubricated, sealed type and require
no maintenance
2. GREASE LUBRICATED BEARINGS require very little attention. More trouble can be caused by
overcharging than by undercharging with grease. Approximately every month, depending on
service, inject a small quantity of grease (Esso Andok No. 280 or equal} into bearing container
after removing the grease outlet plug so that old grease is flushed out and bearing is not over
-
filled.
A systematic inspection made at regular intervals, giving special attention
to the following, will ensure years of trouble-free operation.
BEARINGS
I.O.M - 880RI SERIES
IOM 880RI.indd 7 2017-11-14 13:04:00