?
2004, FlisKits, Inc., All rights reserved
Triskelion Instruction Sheet: FK-INS-SP010 Rev: B
a. First, make sure that your igniter is intact with no
wires touching each other.
b. Place igniter into the motor nozzle until it will go no
further (when it stops, the tip of the igniter is in contact
with the propellant)
c.
Take a small square of recovery wadding, roll it into a
tight ball and, using a pencil or other pointed object,
push this into the nozzle, securing the igniter in place,
as shown in
Figure F.
d.
NOTE:
Do
NOT
use tissue paper as this can cause
fires at the launch pad.
e.
Figure G
shows a cut-away view of the motor with the
igniter properly installed.
FIGURE F
FIGURE G
5. Place your model on the Launch Pad and attach the two
micro clips to the igniter wires (
NOTE:
Be sure that these
clips do not touch each other)
6. Clear the launch area and alert your recovery crew!
7. Check for low flying aircraft and any unauthorized persons
in the launch and recovery areas!
8.
Arm the launch panel and verify continuity, then
BEGIN
YOUR COUNTDOWN!
5
4
3
2
1
LIFTOFF!
NOTE:
Always follow the
National Association of
Rocketry (NAR) Safety Code
when launching
model rockets. A copy of the Safety Code can be
found on the included warranty card.
