FLIR Raymarine CAM220IP, Руководство по установке

Страница: 7 / 54

Chapter 1: Important information
Certified Installation
Raymarine recommends certified installation by a
Raymarine approved installer. A certified installation
qualifies for enhanced product warranty benefits.
Contact your Raymarine dealer for further details,
and refer to the separate warranty document packed
with your product.
Warning: Product installation and
operation
• This product must be installed and
operated in accordance with the
instructions provided. Failure to do so
could result in personal injury, damage
to your vessel and/or poor product
performance.
• Raymarine recommends certified
installation by a Raymarine approved
installer. A certified installation qualifies
for enhanced product warranty benefits.
Contact your Raymarine dealer for
further details, and refer to the separate
warranty document packed with your
product.
Warning: Powering PoE devices
This device can be powered over its
ethernet connection (PoE) OR via its
dedicated power cable.
NEVER connect the devices dedicated
power cable when the device is being
supplied PoE.
Warning: Positive ground systems
Do not connect this unit to a system which
has positive grounding.
Warning: Power supply voltage
Connecting this product to a voltage
supply greater than the specified
maximum rating may cause permanent
damage to the unit. Refer to the
Technical
specification section for voltage rating.
Warning: Switch off power supply
Ensure the vessel’s power supply is
switched OFF before starting to install this
product. Do NOT connect or disconnect
equipment with the power switched on,
unless instructed in this document.
Caution: Power supply protection
When installing this product ensure the
power source is adequately protected
by means of a suitably-rated fuse or
automatic circuit breaker.
Warning: Ensure all equipment has
isolated power supply
This product features an isolated power
supply. To prevent potential damage to
equipment, Raymarine recommends that
any external equipment connected to this
product also features an isolated power
supply.
Power Over Ethernet (PoE)
PoE is a system which allows electrical power to be
passed from a PSE (Power Sourcing Equipment)
device along the ethernet connection to supply power
to a PD (Powered Device). This allows a single
cable to be used to provide both data connection
and electrical power to compatible devices.
PoE Classifications
PSE devices detect the indicated power range /
classification of connected PDs and allocate the
necessary maximum power based on the PDs
classification
The PoE classifications are as follows:
PoE Class
Current
(mA) Power range
(Watt) Class
description
Class 0 0 to 4 0.44 W to
12.94 W
-
Class 1 9 to 12 0.44 W to
3.84 W Very low
power
Class 2
17 to 20 3.84 W to
6.49 W Low power
Class 3 26 to 30 6.49 W to
12.95 W Mid power
Class 4 36 to 44 12.95 W to
25.5 W High power
The PSE will always allocate the maximum power
based on the classification of the PD.
Caution: Service and maintenance
This product contains no user serviceable
components. Please refer all maintenance
and repair to authorized Raymarine
dealers. Unauthorized repair may affect
your warranty.
Water ingress
Water ingress disclaimer
Although the waterproof rating capacity of this
product meets the stated IPX standard (refer to the
product’s
Technical Specification ), water intrusion
and subsequent equipment failure may occur if the
product is subjected to commercial high-pressure
washing. Raymarine will not warrant products
subjected to high-pressure washing.
Important information
7