Adjusting Zoom and Focus
A
B
Adjust the camera’s zoom and focus using an NVR, the web interface,
or on the camera. For more information, see your NVR’s instruction
manual on
flir.com/security/pro
.
NVR:
Right-click on the camera’s live view and then click
AutoFocus
. Use the sliders to adjust the zoom and focus.
Web Interface:
Use the controls in the right-hand panel to adjust
the zoom and focus.
Package Contents
• 8MP Network Bullet Camera
• 4× Mounting Screws & Drywall Anchors
• Security Screwdriver
• Mounting Template
• RJ45 Cap
• Video Test Cable
Connecting the Camera
A
D
Power Input:
If not using PoE, connect the camera to a
24VAC power source. See the rating label on the camera
for minimum power requirements.
Ethernet Connector:
Connect the camera to an NVR
or a router or switch on your network using CAT5e or
better Ethernet cable (not included). PoE+ supported
(802.3at).
NOTE:
For instructions on weatherproofing the Ethernet
connection, see “Using the RJ45 Cap (Optional)” on the
back of this guide.
B
C
Alarm I/O (optional):
Connect alarm/sensor devices (not
included).
Audio I/O (optional):
Connect a self-powered microphone
(audio in) or speaker (audio out).
A
B
C
D
C
Manual Zoom In/Out:
Located in the camera’s service
compartment, press
T
to zoom in and
W
to zoom out.
Service Compartment Overview
A
B
ATTENTION:
You must connect the camera to a supporting H.265 NVR to take
advantage of H.265 compression. For more information, see your IP
camera’s instruction manual on
flir.com/security/pro
.
Use the included mounting template to mark holes for
the mounting screws and camera cable.
ATTENTION:
Test the camera prior to selecting a permanent mounting location by
temporarily connecting the camera(s) and cables to the NVR.
Installing the Camera
1
Drill holes for the mounting screws and camera cable.
NOTE:
Use the included drywall anchors if needed.
2
3
4
5
7
Connect cables as shown in the section “Connecting the
Camera”.
Attach the camera base to the mounting surface using
the included mounting screws (4×).
Use the included security screwdriver to loosen the
adjustment screw on the camera base. Make the
necessary camera angle adjustment.
Remove the vinyl film from the camera lens when your
installation is complete.
Camera Overview
N357B8_QSG_EN_R2
B
A
D
C
A.
Light Sensor and IR LEDs
B.
Sun Shield Screw
C.
Adjustment Screw
D.
Camera Base
E.
Service Compartment
Mounting
screws (4×)
Camera
base
Mounting
surface
Drywall
anchors (4×)
Adjustment
screw
E
Use the included security screwdriver to open the
compartment cover.
Close the compartment cover and secure the screws
when finished.
A
C
D
A.
microSD Slot
:
Insert a microSD
card (not included) into the slot.
microSD card Class 10
supported.
B.
For service purposes only.
C.
Reset Button
:
Press and
hold the button for
5 seconds using a
thin object to reset the
camera to default settings.
B
Tighten the adjustment screw when finished.
6
E
D.
Manual Zoom In/Out:
See
“Adjusting Zoom and Focus”
section for details.
E.
For service purposes only.
