7.1. Plugging and Unplugging
FLIR Detection
7.1
Plugging and Unplugging
The FLIR identiFINDER R300 draws a current of approximately 400 mA. Before connecting to
a computer, please make sure the USB outlet of the computer complies with this requirement.
This might not be the case with some laptops, netbooks or similar battery powered devices.
Figure 179.
Connecting the FLIR identiFINDER R300 (Mini USB-B connector) and a computer (USB-A
connector)
The USB socket of the FLIR identiFINDER R300 is at the lower end of the instrument. It is covered
by a lap in the rubber boot (Figure
, p.
).
Figure 180.
USB socket covered by a lap in the rubber boot
Use the Mini USB-B to USB-A cable supplied with the FLIR identiFINDER R300 to establish the con-
nection.
You can use any equivalent third-party USB 2.0 cable.
168
identiFINDER
®
R300/en/2014.4(13623)/Feb2015