380926 -EN-V7.1-3/12
7
Automatic / Manual Range Selections
The meter defaults to the autoranging mode when turned on. "
AUTO
" will appear in the display.
To select manual ranging, press the
RANGE
key. Momentary presses of the
RANGE
key will
step through the ranges. To return to the Auto Range mode, press and hold the
RANGE
key for 2
seconds.
Relative Reading Measurements
Press the
REL
key to enter the relative mode. "
REL
" will appear in the display. In the relative
mode, the meter stores the reading that was on the display at the time of the
REL
key is pressed
and displays the difference between the measured value and the stored value
Press the
REL
key to return to normal mode.
Data Hold / Backlight key
Press the
HOLD
key momentarily to freeze the present reading on the LCD."
H
" will appear in the
display. Press
HOLD
again to return to normal operation.
Backlight
Press and hold the
Hold
key for 2 seconds to activate the backlighting. The backlight will
automatically turn off to conserve energy after approx 12 seconds.
MAINTENANCE
Battery Replacement
When the low battery symbol appears on the LCD, replace the meter’s 9V battery.
1.
Remove power to the meter and remove test leads from meter
2.
Remove the Phillips head screw (back of meter) and open the battery compartment.
3.
Remove and replace the 9V battery.
4.
Replace the compartment cover and rear screw.
You, as the end user, are legally bound (
EU Battery ordinance
) to return all used
batteries,
disposal in the household garbage is prohibited!
You can hand over your
used batteries / accumulators at collection points in your community or wherever
batteries / accumulators are sold!
Disposal:
Follow the valid legal stipulations in respect of the disposal of the device at
the end of its lifecycle
Fuse Replacement
NOTE
: Fuse Rating: 500mA (5mm x 20mm diameter)
1.
The meter is provided with one overload protect 500mA fuse for current measurements
(direct input NOT clamp measurements).
2.
To replace the fuse, open the meter case by removing the battery cover and battery and then
the four screws holding the rear case.
3.
The fuse is located on the Main PCB.
4.
Replace fuse and secure meter case.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
