FLIR E60BX Series, Руководство по началу работы

Страница: 30 / 112

EN-US English
4. Carefully push the lens into position.
Mounting an additional
lens
1. Note the two indents on the front of
the lens and the corresponding tabs
on the lens cap.
5. Rotate the lens 30° clockwise.
2. Use the lens cap as a tool to remove
the plastic front of the lens. Rotate
the plastic front 30° degrees counter-
clockwise.
To keep in mind
• Adjust the focus first. When the
camera is out of focus, the
measurement is wrong.
• By default, most cameras adapt the
scale automatically. Use this mode
3. Note the index marks on the lens
first, but do not hesitate to set the
bayonet mount and on the
scale manually.
replacement lens.
• A thermal camera has a resolution
limit. This depends on the size of the
detector, the lens, and the distance to
the target. Use the center of the spot
tool as a guide to the minimum
possible object size, and get closer if
necessary. Make sure to stay away
from dangerous areas or live electrical
components.
• Be careful when holding the camera
perpendicular to the target—you can
become a source of infrared radiation
through reflection.
• Select a zone of high emissivity, i.e.,
an area with a matte surface, to
perform a measurement.
© 2011, FLIR Systems, Inc. All rights reserved worldwide. 30
Publ. no. T559524, rev. 014