Camera Base
FOCUS
ZOOM
Installing the Camera
ATTENTION
- Test the camera prior to selecting a permanent
mounting location by temporarily connecting the camera(s) and
cables to the DVR.
Image Sensor
1/3” Sony EX-View™ II 960H
Video Format
NTSC
Effective Pixels
H: 976 V: 494
Horizontal Resolution
700+ TVL
Scan System
2:1 Interlace
Sync System
Internal
S / N Ratio
>52dB (AGC Off)
Iris
Auto Iris
AES Shutter Speed
1/60 ~ 1/100,000 sec.
Min. Illumination
0.03 LUX @ F1.2 (IR Off)
0 LUX (IR LEDs ON)
Video Output
Composite 1.0Vpp @ 75ohm
Lens Focal Length / Type
2.8–10.5mm F1.6 / Varifocal AI
FOV (Diagonal)
38–104°
Termination
Video: BNC Female
IR Range / Qty.
100ft / 31m; 35 LED’s
Power Requirement
12V DC ± 10% / 24V AC ± 10%
Power Consumption
12V: 650mA max / 24V: 325mA max
Operating Temp. Range
–4° ~ 122°F / –20° ~ 50°C
Environmental Rating
IP66
Dimensions (LxWxH)
4.8” x 4.8” x 4.1”
119mm x 119mm x 80mm
Weight (including stand)
1.4lbs / 0.6kg
Dimensions
Camera Specifications
Setting up the Camera
1. Connect the BNC connector of the camera
to the video cable.
2. Connect power source to the power
terminal block.
NOTE:
Make sure to follow correct polarity as marked on the
power connector. For AC power, connect multiple cameras
using consistent wiring polarity to prevent video rolling.
1. Rotate the camera base counter
clockwise to separate it from the ball
camera and dome cover.
2. Mount the camera base to the wall or
ceiling using the included screws.
3. Feed the BNC/power termination cable
through the camera base. Connect
video and power cable as described
in the next section, ‘Setting up the
Camera’.
4. Position the dome cover over the
camera and screw it clockwise half way
onto the camera base.
5. Move the ball camera to the desired
position, and while holding the ball
camera firmly in place, screw the dome
cover the rest of the way to secure it to
the camera base. Holding the camera
prevents it from moving while installing
the dome cover.
119mm / 4.7”
80mm
3.1”
3. Use a screwdriver to adjust the ZOOM and
FOCUS control screws as required.
Video connector
Power terminal block
(pre-attached)
Power connector