1. Use the camera base to drill holes for the
mounting screws and cable.
NOTE:
Insert the included drywall anchors if installing
the camera in drywall.
2. Connect the video and power cables as shown in
the next section ‘Setting up the Camera‘.
3. Mount the camera stand to the desired surface
using the included mounting screws.
Installing the Camera
4. Set the position and angle of the camera using
the provided Allen key.
Setting up the Camera
1. Connect the BNC connector of the camera to
the video cable.
2. DC Power—
Power Adapter
: Connect a
12V DC power adapter (not included) to the
camera. Plug the power adapter into a local
power outlet.
• DC Power—
Power Pigtail
(not included):
Connect a power pigtail to the camera.
Connect the terminating wires of the cable
directly to the DC power source.
NOTE:
For pigtail connection with 12V DC, make sure
to check polarity specifications on the power adapter.
ATTENTION
- Test the camera prior to selecting a permanent
mounting location by temporarily connecting the camera(s) and
cables to the DVR.
ATTENTION
- This camera includes an Auto Mechanical IR Cut Filter.
When the camera changes between Day/Night viewing modes, an
audible clicking noise may be heard from the camera. This clicking is
normal, and indicates that the camera filter is working.
B
C
B) Loosen lower screw with the
included Allen key to adjust the
camera’s vertical position.
C) Loosen upper screw
with the included Allen
key to rotate the camera
housing.
A
A) Turn the adjustment ring to tighten / loosen the
stand connection. Adjust the camera’s horizontal
position.
5. Remove the protective film from the camera lens.
Image Sensor
1/3” Sony Exmor™ Megapixel CMOS
Video Format
NTSC
Effective Pixels
H: 1305 V: 1049
Horizontal Resolution
900 TVL
Scan System
2:1 Interlace
Sync System
Internal
S / N Ratio
48dB (AGC Off)
Iris
AES
AES Shutter Speed
1/60 ~ 1/100,000 sec.
Min. Illumination
0.01 LUX (IR Off)
0 LUX (IR LEDs ON)
Video Output
Composite 1.0Vpp @ 75ohm
Lens Focal Length / Type
3.6mm F2.0 / Fixed
FOV (Diagonal)
92°
Termination
Video: BNC Female
IR Range / Qty.
90ft / 27m
;
24 IR LED`s
Power Requirement
12V DC ± 10%
Power Consumption
12V: 345mA MAX with IR LED
Operating Temp. Range
–4° ~ 122°F / –20° ~ 50°C
Environmental Rating
IP66
Dimensions (LxWxH)
8.2” x 2.5” x 2.7”
209mm x 64mm x 68mm
Weight (including stand)
0.9lbs / 0.4kg
Dimensions
Camera Specifications
209mm / 8.2”
68mm / 2.7”
64mm / 2.5”
