Installation / Operation Manual
anemoi
02.04.2022 | V1.02
-15-
Figure 5-1: Sensor Unit Front View
5.1
Display 1 / Display 2 Connector
Displays 1 and 2 use a standard RJ12 connector (6P/6C). Pins 1 and 2 are supplied with +5 VDC, Pins 5
and 6 are ground. The extended pin allocation is shown in Table 5-2.
Pin Number
Signal Name
Function
1
PWR_OUT
Display Unit Power Supply, +5 VDC
2
PWR_OUT
Display Unit Power Supply, +5 VDC
3
BUTTON
Display Unit Button line
4
DATA
Display Unit Data line
5
DISPLAY_GND
Display Unit Power Supply Ground
6
DISPLAY_GND
Display Unit Power Supply Ground
Table 5-2: Pin allocation Display 1 / Display 2
Figure 5-2: Display Connector pin allocation
5.2
GPS NMEA Connector
If an NMEA RS-232 output device is used as a GPS source, in most installations no specific action
beyond simple plug-in of the RJ45 connector is required.
DISPLAY 1
DISPLAY 2
MICRO SD
GNSS NMEA
POWER
GNSS ANTENNA
P TOTAL
P STATIC
1 2 3 4 5 6
