Measure the length of the engine
from the firewall mounts to the
prop thrust washer for the proper
distance allowing 1/4" to 1/2" from
the dege of the cowl.
Move if needed.
Draw the engine ecnter line and
thrust line darker with a ball point.
Note the 2 degree right thrust built
in to the firewall.
The cowl is already built with this
offset as well.
Use the drill template if you are
going to use a DA 50 or measure
your engines mounting location.
Remember the engine is mounted
inverted.
Determine where the throttle arm
push rod is going to the firewall
and drill a hole.If you are going to
use a Nyrod,then make the hole
the same size as the outsider
red tube.
ENGINE
Page8
