Open the battery compartment and insert three AAA batteries
Make sure that you match the polarities (+ and -) as marked inside
Replace the cover and screw in place
Installing Batteries
%
Place the HoverCross on a flat surface as in hover mode
%
Plug the mini USB on the charge cord as shown and the
USB charger into a 5V USB power source
%
Green LED’s show while charging and turn off when
charge is complete
%
Charging should take between 35 and 40 minutes
%
When the charge is complete, unplug both connectors
%
Use only the included USB charge cord
Charging Instructions
Charge Port
On/Off
%
Press the On/Off button on the transmitter. Press and hold the On/Off button on the aircraft
until the red LED on the aircraft begins to blink. When you remove your finger, the LED’s on
the aircraft and the transmitter will turn solid red to show they are now paired. To arm the
motors, move the left stick to the top until you hear one beep, then pull the stick all the way
down until you hear a second beep.
%
In hover mode, press the Auto-Take Off/Land button or move the left stick up and the Hover
Cross will begin to move forward. To take off in drone mode, press the Auto-Take Off/Land
button and the unit will climb to an altitude of 1.5 to 2 meters and maintain a steady hover.
%
See the transmitter diagram for movements and control during operation.
%
If the HoverCross tends to “drift” in any direction during flight, use the trim buttons as shown in
the transmitter diagram.
Operating Instructions
%
%
%
Forward
Backward
Move Left Move Right
Ascend
Descend
Rotate Right
Rotate Left
360° Flips (R)
Mode Flips (L)
ON/OFF
Trim Forward/Backward
Trim Left/Right
3 Rates Slider
