
Rev:
C
Revision Date:
08/27/2012
Page 9 of 22
MAN – FD320LIFT-LP Ver HD
RS-485 Wiring
Shielded twisted-pair 22 AWG wire is recommended for RS-485 wiring.
HDMI
HDMI (High-Definition Multimedia Interface) defines the protocol and electrical
specifications for the signaling, pin-out, electrical, and mechanical requirements of
cable and connectors used for transmitting High-Definition content. The Type A HDMI
connector (shown below) has 19 pins with bandwidth to support all SDTV, EDTV, and
HDTV modes. The plug's outside dimensions are 13.9 mm wide by 4.45 mm high.
ECS manufactures an HDMI cable that is terminated at the factory. It is ordered as
part number 600-19786-XXX, where XXX is the length in inches for the desired cable.
Also available from Flight Display Systems is an HDMI to Cat5e/6 converter, which
drastically reduces the cost of cabling while increasing the maximum allowable cable
run to 100ft for High-Definition Video. The FDC5TX (Converts HDMI to Cat5e or Cat6)
and FDC5RX (Converts Cat5e or Cat6 to HDMI) is available for use with
(RECOMMENDED CABLING). Additional information on this product can be found on
the Flight Display Systems website and in the associated manual for these products.
All manuals and user guides at all-guides.com