5
Flush mount tweeter installation
For ease of installation there are two ways of
fi
xing the tweeters in place.
The
fi
rst requires the use of the metal ring provided. (
See Figure A
)
• After
fi
nding a suitable position for the tweeters place the cut out template for the tweeter in position and
mark around it.
• Before cutting the holes double check that no brake, fuel lines or wiring harnesses are likely to get
damaged.
• Ensure that the tweeter when
fi
tted will not catch on any moving parts such as door / window handles.
• If mounting in a door check that the window can still be fully lowered before installing.
• Cut out the hole carefully.
• Place the entire tweeter into the cut out hole.
• From the back push the metal ring over the rear of the casing until it is tight into the hole.
The second requires the use of the metal strip provided. (
See Figure B
)
• After
fi
nding a suitable position for the tweeters place the cut out template for the tweeter in position and
mark around it.
• Before cutting the holes double check that no brake, fuel lines or wiring harnesses are likely to get
damaged.
• Ensure that the tweeter when
fi
tted will not catch on any moving parts such as door / window handles.
• If mounting in a door check that the window can still be fully lowered before installing.
• Cut out the hole carefully.
• Position the metal strip
fi
xing strip centrally, behind the cut out hole.
• Using the
fi
xing screws attach the base of the tweeter case to the metal strip.
• Pass the tweeter cable through the hole in the centre in the bottom of the case and the metal
fi
strip.
• Pull the cable tight until the tweeter sits in the base.
• Screw the top of the tweeter casing to the base.
• Caution do not over tighten.
Crossover
The crossover units come with wires with crimped ends on already attached to them to ease the
installation process. The wiring diagram (left) should be used as a guide to wire the crossovers into
your system Once the crossover has been wired correctly use the two sticky pads to
fi
x it to a
secure, dry location.
●
Screw the top of the tweeter casing to the base.
●
Caution do not over tighten.
