FlexWATCH User Manual Part 2
M4028
25
Seyeon Tech Co., Ltd
5.
To check whether your Network configuration is correctly applied or not, press ‘ifconfig’
command, then following messages will show up. On the second line of the ‘eth1’
message, you can check the assigned IP and Mask values. Gateway value is not seen
here. If the values are different from what you want to set-up, try again the Network
configuration from step 4.
Bash#
ifconfig
eth0 Link encap:Ethernet HWaddr 00:30:6F:48:64:86
inet addr:10.20.30.40 Bcast:10.20.30.255
Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:9
eth1 Link encap:Ethernet HWaddr 00:30:6F:48:E4:86
inet
addr:192.168.0.253
Bcast:10.255.255.255
Mask:
255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1453 errors:0 dropped:0 overruns:0 frame:0
TX packets:62 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:10 Base address:0x2100
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:309 errors:0 dropped:0 overruns:0 frame:0
TX packets:309 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
2.4.3. Connection to Home Page
Run Internet Explorer Browser and enter the IP address. Then it will connect to the homepage of
FlexWATCH server.
