webdyn.com
V1.03 subject to changes | Webdyn © by Flexitron Group
40
7.8 Power on LTE Modem and Check Operation
•
Once LTE Modem is completely installed (fixed, wired and closed) it can be powered up.
• Apply energy source at Mains Power Supply.
• After power on, check system check Status Leds to verify Modem is working properly.
POWER STATUS LED
ON
Power is properly connected and according required specifications
Fast
Boot failure: contact technical Support. LTE Modem is not operating properly
Slow
MAINS Power energy is lost: operation with backup super-capacitor; will send power
lost trap and go into power-down mode
OFF
System is not properly powered on: check mains power supply energy is available and
within required specifications; check cabling is properly installed
COVERAGE STATUS LED
3 blinks
Starting router after system reset.
ON
Good coverage
Slow/Fast/ON
Sim detected and ready
Fast
Low coverage: verify Antenna is properly installed; check LTE Modem location
coverage is enough with auxiliary coverage meter
Slow
Not enough/critical coverage: verify Antenna is properly installed; check LTE
Modem location coverage is enough with auxiliary coverage meter
OFF
SIM undetected or incorrect PIN: verify SIM Card is properly installed; SIM
Card cannot be installed with Modem LTE powered-on
WAN STATUS LED
ON
4G Network - APN connection ON
Fast
3G Network - APN connection ON
