05
06
Bundle the cables with
cable management zip
Cable
Make sure the cables are long enough
to accommodate the full range of
motion, so as to avoid equipment
damage or personal injury.
Careful
●
●
●
●
“
^
”
How to use handswitch
Adjust the desk upwards
Adjust the desk downwards
Stand Position Button, touch about 2 seconds,
and your stand height is saved.
Sit Position Button, touch about 2 seconds,
and your sit height is saved.
Button
Upwards
Downwards
Handset Instruction
Instruction:
Touch Button Lift Function:
The height of the elevator can be adjusted up or down by touching the " " or "v" button
^
and the current height is displayed on the screen with a height range of 5.9" ~ 18"
.
Note that it only needs a touch of the button with your finger to operate the workstation.
Height Memory Function:
a. Touch the up or down button to adjust the workstation to your desired height, for
example
b. Touch for about 2 seconds, the display shows “Stand”, and the position of the
standing height is saved successfully.
c. Touch for about 2 seconds, the display shows “Sit”, and the seat height position
is saved successfully.
d. Touch the corresponding standing or sitting button, and workstation will automatically
raise and lower to the corresponding height position saved previously.
Code Processing:
a. Reset function: The display shows “RST”. At this time, touch the down button until the
table is lowered to the lowest position. When the display shows the lowest height (15),
the workstation is reset successful and can be used. Note: When resetting, keep net
under the workstation. Books, pens, etc. will cause reset failure.
b. If an abnormal code appears, you need to touch the downward button to reset.
c. If an abnormal code appears, you touched the downward button and there was no
response, please power off for more than 10 seconds, and then press the downward
button again to reset. If it cannot be reset after doing so, please confirm whether it
works for a long time (continuous lifting for more than 2 minutes). If so, please take a
break for more than 18 minutes before adjust the workstation.
Organizing Your Cables 3
