Flexcom Communication Ltd
Installation and operating instructions (2021/06/09)
14/23
Switching on and off
The device turns on automatically when charged. In addition, you can turn it on or off at any time
using the power button. The button responds by holding down for a few seconds, in which case the
LED display flashes green.
The device automatically connects to GSM and satellite networks after start-up. The current status is
indicated by the LED displays.
If the appropriate satellite connections are available, positioning will be based on these data. If not,
the device performs position calculation (LBS) based on the position of the transmission towers of the
mobile service providers.
Restart
The Reset button on the top of the device can be accessed through the hole, e.g. using a paper clip
stem or needle. Pressing it will restart the device.
Charging the battery
The device is powered by a built-in battery, which needs to be charged at different intervals
depending on the intensity of use. Your phone charger is suitable for charging, but you can also use
the USB connection of a computer or energy bank. During charging, the LED flashes red. When the
device is fully charged, the light turns off.
Charging takes a few hours. When the battery is fully charged, disconnect the charging
cable. The device does NOT have overcharge protection, so prolonged or continuous
charging will shorten the life of the device or, in worse cases, damage it.
For the device with a voltage of 5V 1 Use a charger that provides current. Chargers with
a higher capacity can damage the battery.
Operating time
The device operates continuously connected to an external (vehicle) power supply. Own battery max.
Allows 2 hours of operation.
Normal operation of the device
The device can be operated in the following ways:
using the software service provided by the distributor and the SIM card together, in addition to
1.
Flexcom