Flexcom Communication Ltd
Installation and operating instructions (2021/03/16)
13/25
Unscrew the protective cover.
1.
Insert the card into the slot on the left side of the watch, chip up, in the direction of the buttons.
2.
Screw the protective cover back on.
3.
Charging the battery
The watch is powered by a built-in battery, which needs to be charged at different intervals
depending on the intensity of use. The magnetic charging cable connector is located on the back of
the device. The correct connection of the cable is facilitated by the attraction / repulsion of the
magnet.
During charging, the LED on the front of the watch flashes red every 1 second; when the battery is
fully charged, the blinking turns solid green. The charging time is approx. 3 hours.
If the LED display flashes red every 5 seconds, the battery is running low and needs to be charged.
A charger with a maximum current of 1 A may be used for the clock with a voltage of 5V!
Chargers with a higher capacity can damage the battery.
Flexcom