Lacer Operation:
1. Guiding belt through clamp and over
belt support shelf, insert belt end into hook
points and flush against the entire width of
the face strip.
2. Lock belt clamp.
3. Position rollers over hooks.
4. Turn adjusting knob counter-clockwise
until rollers touch hooks.
6. Using cordless drill or manual override,
drive lacer head across the belt width at a low
to medium speed.
5. Return lacer head to end of lacer and turn
adjusting knob 1½ additional turns counter-
clockwise.
8. Remove lacer pin. Release belt clamp.
Remove belt from lacer.
NOTE: The belt will need to be ‘continuous
laced’ if it is wider than the lacer.
7. Turn adjusting knob counter-clockwise 1/2
turn and return head across the belt. Repeat
until hooks are embedded with 1/3 to 1/2 the
wire diameter into the belt.
• Wipe debris off chain-body extrusion periodically with a dry cloth to prolong the UHMW roller life.
• If head begins to rock back and forth on the extrusion after extended use, finger tighten adjusting screws
located on top and bottom of head.
Continuous Lacing Procedures:
1. Starting on one side of the belt, lace the first section using the ‘Lacer Operation’
instructions listed above.
2. Open rollers.
3. Insert hooks into face strip, starting with the first active slot.
4. Insert lacer pin. Remove carding paper from hooks, if applicable.
5. Guiding belt through the belt clamp and over the belt shelf, position laced hooks
into the continuous lacing slots, directly next to the first active slot. Keep belt flush
against the face strip. Clamp belt.
6. Lace this section using Steps 3-8 of the ‘Lacer Operation’ instructions.
Helpful Tip: When continuous lacing it is recommended to lace the shorter length
of belt first and then continue with the longer section of belt. Example: when using
a 24" Roller Lacer to lace a 36" wide belt, lace the 12" section of belt first and then
follow the process to continuous lace the remaining 24" of belt.
Maintenance:
Turn knob 1½ turns
counter-clockwise
1/2 to 1/3 of the wire
diamater should be em-
bedded into the belt.
CONTINUOUS
LACING SLOTS
FIRST ACTIVE SLOT
12525 Wisconsin Avenue • Downers Grove, IL 60515-4200 • USA
Tel: (630) 971-0150 • Fax: (630) 971-1180 • E-mail: [email protected]
Visit
www.flexco.com
for other Flexco locations and products.
©2008 Flexible Steel Lacing Company. Clipper and Roller Lacer
®
are registered trademarks.
10-23-17. For Reorder: X1451
