Instruction manual
XFE 15 18.0-EC / XCE 8 18.0-EC
12
Preselecting the speed
CAUTION
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
–
To set the operating speed, move the dial
to the required value.
–
Gently press the switch to accelerate the
power tool up to the preselected speed.
NOTE
If an overload or overheating occurs during
continues operation, the power tool
automatically reduces the speed until the
power tool has cooled down adequately.
Operating informations
CAUTION
When the power tool is switched off,
the polishing tool continues running briefly.
NOTE
Following a tool change (e.g. wool pad
instead of polishing sponge), the difference
in weight may increase the vibrations.
Change the operating speed with the
adjusting wheel until the vibrations have
been reduced.
–
Switch on the machine before placing it
on the surface which is to be polished and
run the polisher up to the set speed.
–
Move the polishing tool without pressure
and make circular, overlapping
movements on the surface to be polished
in order to achieve good polishing results
and to prolong the service life of the tool.
–
If using a polishing paste, use the
respective tool for each paste.
For further information on the manufacturer’s
products go to www.flex-tools.com.
Charger
1
Insertion slot for battery
2
Contacts
3
Ventilation slots
4
Operating state display
5
Power cord with mains plug
The CA 12.0/18.0 charger is designed to
charge FLEX batteries of the following types
–
AP 12.0 (2.5 Ah),
–
AP 18.0 (2.5 Ah),
–
AP 12.0 (5.0 Ah),
–
AP 18.0 (5.0 Ah).
