Flex XC 3401 VRG, Руководство по эксплуатации

Страница: 18 / 198

Polisher XC 3401 VRG
18
Maintenance and care
Danger!
Before carrying out any work on the
polisher, always pull out the mains plug.
Cleaning
– Regularly clean the power tool and
ventilation slots. Frequency of cleaning
is dependent on the material and
duration of use.
– Regularly blow out the housing interior
and motor with dry compressed air.
Carbon brushes
The polisher features cut-off carbon
brushes.
When the wear limit of the cut-off carbon
brushes is reached, the polisher switches
off automatically.
Note!
Use only original parts supplied by the
manufacturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.
When the polisher is being used, the carbon
brushes can be seen sparking through the
rear air inlet apertures.
If the carbon brushes spark excessively,
switch off the polisher immediately.
Take the polisher to a customer service
workshop authorised by the manufacturer.
Gears
Note!
Do not loosen the screws on the gear
head (4) during the warranty period.
Non-compliance will deem the guarantee
obligations of the manufacturer null and
void.
Replacing a worn Velcro pad
1. Pull out the mains plug.
2. Remove polishing sponge.
3. Place machine on its back.
4. Press spindle lock and loosen and
remove the screw with an Allen key.
Remove Velcro pad.
5. If required, clean the key surface of the
output shaft.
6. Place a new Velcro pad on the output
shaft.
The groove of the Velcro pad must mesh
with the key surface of the output shaft,
if required rotate the output shaft.
7. Screw in the screw and tighten with the
Allen key. Simultaneously press the
spindle lock.
8. Conduct a test run. Check for
imbalances and vibrations.
Book_XC3401.book Seite 18 Donnerstag, 4. Juni 2009 12:30 12