Flex LW 1503, Инструкция по эксплуатации

Страница: 13 / 44

LW 1503 Instruction manual
13
8. Always lift the polisher off the work
before starting or stopping motor.
The arrow on the front gear housing
indicates the direction in which the
polishing wheel rotates.
Use only accessories that are recom-
mended by the manufacturer.
Accessories that may be suitable for one
tool may become hazardous when used
on another tool.
Maintenance
DANGER
Before performing any work on the
electric power tool, pull out the mains
plug.
NOTE
Use only original parts supplied by the
manufacturer for replacement
purposes.
If non-original parts are used, the
guarantee obligations of the
manufacturer will be deemed null and
void.
Keep tool clean
Periodically blow out all air passages
with dry, compressed air. All plastic parts
should be cleaned with soft damp cloth.
NEVER use solvents to clean plastic
parts. They could possibly dissolve or
otherwise damage the material.
CAUTION
Wear safety glasses while using
compressed air.
Failure to start
Should your tool fail to start, test the
GFCI, and check to make sure the
prongs on the cord plug are making good
contact in the outlet. Also, check for
blown fuses or open circuit breakers in
the line.
Gear housing
The gear housing should never be
loosened or opened, except by a FLEX
authorized service center. Doing so will
void the product warranty.
Brush inspection and lubrication
For your continued safety and electrical
protection, brush inspection and
replacement on this tool should ONLY be
performed by an authorized service
center for FLEX Power Tools.
At approximately 100 hours of use, take
or send your tool to your nearest
authorized service center for FLEX
Power Tools to be thoroughly cleaned
and inspected; worn parts replaced;
and when necessary, relubricated with
fresh lubricant if required; reassembled
with new brushes; and performance
tested.
Any loss of power before the above
maintenance check may indicate the
need for immediate servicing of your tool.
DO NOT CONTINUE TO OPERATE
TOOL UNDER THIS CONDITION. lf
proper operating voltage is present,
return your tool to a FLEX authorized
service center for immediate service.
13