-12-
b. Press the drive-control button briefly (less
than 0.5 second) to cycle through the 3
modes. Each press changes one torque level.
See more details in the chart below.
“T” is a special mode for fastening self-tapping
screws into sheet metal. Use only the specified
type of screw and material listed in the chart
below.
T1 and T2 modes help to prevent stripping
the screw head, snapping the screw off, or
damage to work surfaces. In T1 mode, the tool
will stop driving automatically once the screw
head is perfectly flush with the work surface. In
T2 mode, the tool will slow the rotation speed
automatically when the screw head is close to
the working surface, so that you can carefully
drive the screw to final depth, and stop it in time.
To select the “T” mode:
a. Two methods are available to check the
current T mode:
Either depress and release the trigger switch or
press the drive-control button or the “T” button
directly without touching the trigger switch.
The LED indicator below the mode number will
illuminate to indicate the current mode setting.
Press the “T” button briefly (less than 0.5
seconds) to cycle between T1 and T2 modes.
Each press changes one mode. See more
details in chart below:
Lit indicator
displayed on
panel
Woking
mode
Maximum
impact
rate
Purpose
Example of application
1
1300 IPM
Tightening when a good
finishing is needed
Tightening screws into
sensitive boards, such as
plaster boards
2
3600 IPM
Tightening with less force
and speed than mode 3
(easier to control than
mode 3)
Driving screws into hard
materials as well as
tightening bolts
3
4450 IPM
Tightening with the maximum
force and speed
Driving long screws into
hard materials, as well
as tightening bigger bolts
than mode 2
TI
N/A
Driving self-tapping screws
into sheet metal with good
finish
Recommended type:
#8 x 1/2"
Recommended type:
#10 x 1"
T2
N/A
Driving self-tapping screw
into thick metal with good
finish (handing tougher work
compare to T1 mode
Recommended type:
#10 x 1-1/2" or
1/4'' x 2-1/2“
ON ;
OFF
NOTICE:
The variety of wood density and metal
material may affect the final outcome. The user
should select appropriate mode based on the
application.
WARNING
Do not change the working
mode while the tool is
running. Sudden change of torque may cause
the loss of control causing possible injury or
damage to the tool or workpiece.
NOTICE:
The LED indicator will turn off
approximately 1min after the trigger switch is
released.
NOTICE:
When the tool is next turned on, the
working mode will revert to the previous setting.
