Flex FX0111, Руководство оператора

Страница: 4 / 36

-4-
SPECIFIC SAFETY RULES
Before using battery, read all instructions
and cautionary markings on (1) battery
charger, (2) battery pack, and (3) product
using battery.
Risk of fire and burns. Do not recharge,
disassemble, heat above 130 °C (265 °F),
or incinerate. Keep battery out of reach of
children and in original package until ready
to use.
Battery tools do not have to be plugged
into an electrical outlet; therefore, they are
always in operating condition. Be aware
of possible hazards when not using your
battery tool or when changing accessories.
Do not place battery tools or their batteries
near fire or heat. Charge battery pack within
the required temperature range.
Store charger and battery pack in
locations where temperature is within the
recommended storage temperature range.
This is important to prevent serious damage to
the battery cells.
Do not crush, drop or damage the battery
pack. Do not use a battery pack or charger
that has been dropped or received a
sharp blow. A damaged battery is subject to
explosion. Properly dispose of a dropped or
damaged battery immediately.
Do not insert battery pack in charger if
battery pack case is cracked. Using damaged
battery pack may result in electric shock or fire.
Batteries vent hydrogen gas and can
explode in the presence of a source of
ignition such as a pilot light. To reduce
the risk of serious personal injury, never use
any cordless product in the presence of open
flame. An exploded battery can propel debris
and chemicals. If exposed, flush with water
immediately.
Do not recharge battery in damp or wet
environment. Do not expose charger to rain
or snow. Water entering battery charger may
result in electric shock or fire.
Do not store outside or in vehicles.
Do not store battery pack in charger.
Battery
pack stored in charger over a long period of
time could lead to battery pack damage and fire.
Battery leakage may occur under extreme
usage or temperature conditions. Avoid
contact with skin and eyes. The battery liquid
is caustic and could cause chemical burns to
tissues. If liquid comes in contact with skin,
wash quickly with soap and water. If the liquid
contacts your eyes, flush them with water for
a minimum of 10 minutes and seek medical
attention.
Do not let gasoline, oils, petroleum-based
products, etc. come in contact with plastic
parts. They contain chemicals that can
damage, weaken or destroy plastic.
Do not touch the uninsulated portion of
output connector or uninsulated battery
terminal. There is a risk of electric shock.
Replace battery pack if a substantial drop
in operating time per charge is observed.
Battery pack may be nearing the end of its life.
WARNING
•
Some dust created by power sanding, sawing,
grinding, drilling and other construction
activities contains chemicals known to the
State of California to cause cancer, birth
defects or other reproductive harm. Some
examples of these chemicals are:
–
Lead from lead-based paints.
–
Crystalline silica from bricks, cement, and
other masonry products.
–
Arsenic and chromium from chemically-treated
lumber.
•
Your risk from these exposures varies,
depending upon how often you do this type
of work. To reduce your exposure to these
chemicals:
–
Work in a well-ventilated area.
–
Work with approved safety equipment, such
as dust masks that are specially designed to
filter out microscopic particles.
–
Avoid prolonged contact with dust from power
sanding, sawing, grinding, drilling, and other
construction activities. Wear protective clothing
and wash exposed areas with soap and water.
Allowing dust to get into your mouth or eyes or
to lie on the skin may promote absorption of
harmful chemicals.