Flex innovations Pirana, Инструкция по эксплуатации, Страница: 24 / 31

23
AURA QUICK CHANGE MODE
The FT Aura 5 Lite in the Piraña has two optional configurations that can be selected without the use of a PC; Level
Assist and Air Brakes
Level Assist
Level Assist prevents the aircraft from being over controlled by limiting pitch and bank angles and prevents the aircraft
from rotating upside down. It also self-levels the aircraft when the sticks are returned to neutral. Activating Level
Assist replaces Flight Mode 1 in the standard setup.
Air Brakes
Air Brakes are when both rudders deflect in opposite directions toward the center of the aircraft, which causes drag
and slows the aircraft down. The FT Aura 5 Lite uses channel 6 from your transmitter as an on/off switch to control
the airbrakes. While active, the airbrakes are also mixed to the throttle so that simply advancing the throttle will
return the rudders to neutral.
Assign channnel 6 to a 2-position switch in your transmitter if you wish to activate the Air Brakes.
To enter Quick Change Mode, use the following steps:
1. Power ON your transmitter and the aircraft, and verify you are getting a valid signal from the receiver to the
Aura. You should see a solid orange and solid green LED visible on the Aura.
After entering Quick Change Mode you can:
1. Check Sensor Directions
- Roll the aircraft right, to confirm the elevons move in a manner to counter the direction of movement.
- Pitch the nose up, to confirm the elevons move in a manner to counter the direction of movement.
- Yaw the aircraft nose right, to confirm the rudder moves in a manner to counter the direction of movement.
2. Change Flight Mode 1 between Standard (3-Axis) and Level Assist (6-Axis)
- Press and HOLD the BIND button until you see a solid blue LED.
- The servos will cycle back and forth TWICE to confirm Flight Mode 1 has changed to Level Assist.
3. Change Air Brakes from Inactive, to Active
- Press and HOLD the TRIM button until you see a solid RED LED.
- The servos will cycle to confirm the change has been stored.
To save your selections and exit Quick Change Mode:
- Press and HOLD both the BIND and the TRIM buttons again to exit Quick Change Mode and Restart the Aura.
Your changes have now been stored.
Note: Futaba users who wish to use airbrakes must visit our Wiki site for information on how
to configure airbrake setup.
2. Press and hold both BIND and TRIM buttons to enter Quick Change Mode. Quick Change Mode is indicated
by fast a flashing green LEDs.
You can repeat button presses to switch back and forth as many times as necessary.
Note: These movements are exaggerated for clarity while in Quick Change mode, and do not
represent their actual movements in flight.
wiki.flexinnovations.com/wiki/Pirana