C
ONTINUE TO NEXT PAGE TO COMPLETE THE INSTALLATION
Yellow butt connector
Crimp the motor wires to the large
supplied wire.
Large red wire
Colored motor
wire
Step 7: Wire the fan motors (refer to Wiring Diagram, below)
Using the yellow butt connectors provided, attach a length of the large diameter (10 AWG)
red
wire to
the
colored
motor wire. Attach a length of the large diameter (10 AWG)
black
wire to the
black
motor wire. Once the fan is in place, these will attach to the control module.
Tip: Strip an additional
1/8
" of insulation from the motor wires and fold them over to increase the thickness of the
wire where it will slide into the butt connector.
If mounting the control module to the fan shroud,
the motor wires can be connected now (
see wiring diagram, next page
). If mounting the control
somewhere else in the engine compartment, leave enough wire to reach the control module, but do
not connect yet.
Step 8: Wire the control module
Step 8a:
Connect the motor wires to the control module
(Red wire to the "M+" terminal and black wire to the "M-" terminal).
Step 8b:
Disconnect the negative battery lead for safety while finishing the wiring. Use the large
diameter red (10 GA) wire to run power directly from the battery positive (+) terminal to the "B" termi-
nal on the control module. Connect the fuse holder in-line with this wire, as shown, but do not insert
the fuse yet. Use the yellow female, ring, and butt connectors provided.
rev. 10-07-08 99485 Page 2 of 3
colored
Содержание Black Magic Xtreme 485
Страница 4: ......
