FLENDER ZAPEX, Руководство по сборке и эксплуатации

Страница: 69 / 74

Technical specifications
Tightening procedure
M3560-02en Edition 09/2022 69
Size Tightening torque TA
Part no.
Width A/F SW
Part no.
6
Nm
9
Nm
6
1)
mm
9
2)
mm
274 13 210 5 24
307 13 410 5 30
333 13 410 5 30
364 13 410 5 30
424 13 710 5 36
Table A-4: Tightening torques and widths A/F
1)
Hexagon socket
2)
Hexagon head
Apply the specified tightening torques as listed in Section Tightening procedure (Page 69).
A.5 Tightening procedure
Tightening procedure
Tightening torques must be observed taking into account the following table:
Scatter of the torque ap-
plied at the tool Tightening procedure
(As a rule, the tightening procedures listed are within the spe-
cified tool torque scatter.)
±5 % • Hydraulic tightening with mechanical screwdriver
• Torque-controlled tightening with a torque wrench or a torque
wrench that gives a signal
• Tightening with a precision mechanical screwdriver with dynamic
torque measurement
Table A-5: Tightening procedure
The tightening torques apply to screws/bolts with untreated surfaces that are not oiled or are
only lightly oiled, and for screws/bolts that are used with a liquid screw locking agent in ac-
cordance with these instructions. Use with lubricant paint or lubricant is not permitted.
A.6 O-rings
O-rings
A.6.1 Use and storage of the O-rings (12)
O-rings
Note the following concerning the use and storage of the O-rings (12):
• Storage possible for up to 5 years
• Protect against direct sunlight, artificial light with a high UV‐content and extreme temper-
atures