Full System flush (weekly)
It is not recommended to store paint in the machine for longer than 24hrs
1. Ensure that the water tank has sufficient water for the cleaning operation.
2. Position the machine where it can be flushed and cleaned.
3. With the paint/water tap in the ‘water’ position (Fig 17), and the flow return tap
inline with the pipe, turn on the pump. Allow water to circulate into paint tank,
when running clear, turn off pump.
4. The contents of the paint tank can be emptied into a suitable sealed container.
Remove drain cap and tilt machine to empty.
5. Paint tank should be cleaned to remove any excess paint from the bottom and
sides.
6. Replace drain cap and fill with 5 litres of clean water and optional Kombi
Klean.
7. Position the nozzle assembly over a drain or suitable container.
8. With the paint/water change over tap in the ‘paint’ position (Fig 17), turn on the
pump. Allow the water to spray through the nozzle until the paint tank is empty.
9. Remove the bayonet cap complete with the nozzle tip and filter. If necessary,
rinse to clean.
10. Refit the bayonet cap complete with the nozzle tip and filter
11. Using a damp cloth lean any paint overspray from the following:
A. Line forming discs and guide shafts. Build up of paint on the guide
shafts will make line width adjustment more difficult
B. Generally clean and remove paint overspray or spills from the machine
Mainte
nan
ce
12
