FLAVIA TD 55 VENETA P5 GR, Инструкции по использованию и обращению

Страница: 12 / 36

Operation and installation manual
DISHWASHERS
10
WATER SOFTENER
There are two methods to soften water:
either with a water softener, or a washing
agent.
Water hardness values may vary from place
to place. If your dishwasher uses hard wa-
ter, this may lead to formation of scale and
deposits on dishes.
The appliance is equipped with a special
softener to use salt, specially developed
for removal of lime and minerals from water.
HOW TO CHARGE SALT
INTO THE SOFTENER
Make sure to always use salts meant for
dishwashers only.
The salt container is beneath the lower grid.
The way to fill it in is as follows:
1. Remove the lower basket, unscrew the
salt container cover to remove that.
2. If you fill in the container for the first time,
fill it with water (1 l).
3. Insert the funnel end (included) into the
opening, charge approximately 1.5 kg of
salt. It is normal, if some water flows out
of the container.
4. Carefully screw in the cover.
NOTE:
1. The salt container should be refilled,
when the “S” pictogram (upper left cor-
ner of the control panel: Figure 1, Pos. 4)
starts to illuminate. Even if the container
is properly filled, the pictogram may still
illuminate until salt is dissolved com-
pletely.
2. If you have spilled the salt, you can wash
it out, using the “Rapid” program
SALT CONSUMPTION
CONTROL
The dishwasher enables to adjust salt con-
sumption, depending upon water hard-
ness, to optimize it in the way as follows:
1. Press the ON / OFF button, close the
door.
2. Press and hold (within 60 sec) START /
PAUSE.
3. On the front panel, program indicators
will flash, corresponding to settings H1,
H2, H3, H4, H5 and H6. Default setting is
H3.
4. Using START / PAUSE, set a desired
value of salt consumption, depending
upon water hardness (refer to “Water
hardness table”).
5. Settings are completed automatically,
in 5 sec.
These settings are required each time you
disconnect the dishwasher from the mains.
You may be informed of water hardness in