Always keep furniture and combustible materials well clear of the fire and never
dry clothing or items either on or near to the fire. Never use aerosols or
flammable cleaning products near to the fire when it is in use.
The fuel bed remains hot for a considerable period after use and sufficient
time should be allowed for the fire to cool before cleaning etc.
The fire must only be operated with the fender and ash pan cover supplied and in
position.
OPERATING THE FIRE
The controls are located behind the brass cover below the fender. The controls,
comprise a control valve to adjust the gas flow and a push button piezo igniter. To
light the fire proceed as follows:-
1)
Depress the control knob and turn anti-clockwise to the position marked pilot.
Hold in the control knob for a few seconds to allow the gas to reach the pilot.
2)
Continue to hold-in the control knob and press the igniter button. If the pilot
does not light, continue to press the igniter button until ignition occurs. The
pilot flame can be seen by looking across the front line of the burner. When
the pilot has lit, continue to hold the control knob in for 5-10 seconds to allow
the thermocouple to heat up, if the pilot goes out when the control knob is
released, repeat the lighting sequence.
After lighting, turn the control knob in the anti-clockwise direction to the high
position and the main burner will light. To gain the most efficient
performance, it is recommended that the control is left in the high position for
5 to 10 minutes
3)
The gas control can be turned clockwise from the maximum position to give
the desired heat output.
4)
To turn the fire off push in and turn the control valve fully clockwise in to the
off position, the burner and pilot will go out.
WHEN TURNING THE FIRE “OFF” PLEASE ENSURE THAT THE CONTROL
VALVE IS TURNED TO THE “OFF” POSITION AND THE PILOT FLAME IS
EXTINGUISHED. DO NOT LEAVE THE PILOT FLAME ONLY LIT.
WARNING : If the fire goes out for any reason or is turned off and it is neces-
sary to re-light the fire it is important to allow the fire to cool for a full 5 min-
utes before attempting to re-light it.
4
