Flavel FWMI721, Руководство по эксплуатации

Страница: 9 / 40

9 / EN
Washing Machine / User’s Manual
Adjusting the feet with water level
• You must remove the Detergent Drawer to
set the Water Level.
• For the system to operate properly, the
bubble inside the Water Level must be in
the
middle
.
• If the bubble inside the Water Level is on the
left , the pre-set right foot of the Washing
Machine must be adjusted.
• If the bubble inside the Water Level is on the
right , the pre-set left foot of the Washing
Machine must be adjusted.
• If the bubble inside the Water Level is at
the back , the pre-set front feet of the
Washing Machine must be turned to the left
(clockwise).
• If the bubble inside the Water Level is at the
front , the pre-set front feet of the Washing
Machine must be turned to the right (anti-
clockwise).
4.1.7 Electrical connection
Connect the product to a grounded outlet
protected by a 13 A fuse. Our company shall
not be liable for any damages that will arise
when the product is used without grounding in
accordance with the local regulations.
• Connection must comply with national
regulations.
• The wiring for the electrical outlet circuit
must be sufficient to meet the appliance
requirements. Use of a Groud Fault Circuit
Interrupter (GFCI) is recommended.
• Power cable plug must be within easy reach
after installation.
• If the current value of the fuse or breaker
in the house is less than 13 Amps, have a
qualified electrician install a 13 Amp fuse.
• The voltage specified in the “Technical
specifications” section must be equal to
your mains voltage.
• Do not make connections via extension
cables or multi-plugs.
A
CAUTION!
• Damaged power cables must be replaced
by the Authorised Service Agents.
Electrical requirements
Before you insert the plug into the wall socket
make sure that the voltage and the frequency
shown in the rating label corresponds to your
electricity supply.
We recommend that this appliance be
connected to the mains supply via a suitable
switched and fused socket in a readily
accessible position.
Should the mains lead of the appliance
become damaged or need replacing at any
time, it must be replaced by a special purpose
made mains lead which can only be obtained
from a Authorised Service Agent.
B
WARNING!
• This appliance must be earthed
If the fitted moulded plug is not suitable for
your socket, then the plug should be cut off
and an appropriate plug fitted.
Destroy the old plug, which is cut off as a
plug with a bared cord could cause a shock
hazard if inserted into a socket elsewhere in
the house.
The moulded plug on this appliance
incorporates a 13A fuse. Should the fuse need
to be replaced an ASTA approved BS1362
fuse of the same rating must be used. Do not
forget to refit the fuse cover. In the event of
losing the fuse cover, the plug must not be
used until a replacement fuse cover has been
fitted. Colour of the replacement fuse cover
must be the same colour as that visible on the
pin face of the plug. Fuse covers are available
from any good electrical store.