3.2
LIGHTING THE APPLIANCE
IMPORTANT : IF THE BURNER IS EXTINGUISHED FOR ANY REASON YOU
MUST ENSURE THAT YOU WAIT A FULL FIVE MINUTES BEFORE ATTEMPT-
ING TO RE-LIGHT THE FIRE.
a)
Turn on the gas restrictor at the inlet fitting.
b)
Depress the control knob and turn anti-clockwise to the position marked
pilot. Hold in the control knob for a few seconds to purge the pipe work.
c)
Continue to hold-in the control knob and press the igniter button. If the
burner does not light, continue to press the igniter button until ignition
occurs. Continue to hold the control knob for 5-10 seconds to allow
thermocouple to heat up, if the pilot goes out when the control knob is
released, repeat the lighting sequence.
d)
Turn the control knob in the anti-clockwise direction to the high position
and the main burner will light.
e)
Turn the control knob clockwise to the low position and the gas input
will be reduced to the minimum setting.
f)
Slightly depress the control knob and turn to the pilot position, the main
burner will go out but the pilot will remain lit.
g)
Slightly depress the control knob and turn to the off position, the pilot
will now be extinguished.
h)
After ensuring that the fire is safe to use it should be left on high
position to fully warm up. During this time a slight odour may be
noticed, this is due to the “newness” of the fire and will soon disappear.
WHEN TURNING THE FIRE “OFF” PLEASE ENSURE THAT THE CONTROL
VALVE IS TURNED TO THE “OFF” POSITION AND THE PILOT FLAME IS
EXTINGUISHED. DO NOT LEAVE THE PILOT FLAME ONLY LIT.
3.3
FITTING THE TRIM & FRET
a)
Push the decorative trim onto the magnets on the fire body, and secure
in place. Remove the protective trim before use.
b)
The firebox is supplied with 2 fender fixing brackets and screws which
should be fixed to the holes in the fender, the flanges on the brackets
should be facing towards the outside of the fender.
c)
Place the fender in position by locating the fender brackets between the
trim and the fire body.
d)
Locate the ashpan cover.
Finally, hand the Installation and Maintenance Instructions and the Users
Instructions over to the customer and explain the operation of the fire.
NOTE : THIS APPLIANCE IS DESIGNED TO WORK SAFELY AND
EFFECTIVELY DURING ADVERSE WEATHER CONDITIONS.
HOWEVER, DURING SUCH TIMES FLAME DISTURBANCE MAY BE
NOTICED. THIS IS NORMAL AND DOES NOT EFFECT OR IMPAIR
THE SAFETY OF THE APPLIANCE.
19
