4.2
Removing the Remote Gas Valve from the fire
4.2.1
Prepare work area (lay down dust sheets etc.)
4.2.2
Remove the burner assembly as described in section 4.1.
4.2.3
Disconnect pilot, main and injector pipes and disconnect the wiring loom
thermocouple and ignition wire, the valve can then be removed.
Re-assemble in reverse order, refit the burner heat shield then refit the
coals referring to section 3 for the correct coal layout. Refit the glass
panel and glass panel retaining trims. The fender and ash pan cover or
fascia can now be re-positioned.
4.3
Removing the Pilot Assembly
Note : Because this appliance is fitted with an atmosphere sensing ‘Oxy-
Pilot’ it is not possible to replace the thermocouple separately, because the
thermocouple position is factory set to a tight tolerance. Any replacement of
parts on the pilot requires a complete new pilot assembly.
4.3.1
Prepare work area (lay down dust sheets etc.)
4.3.2
Remove the burner assembly as described in section 5.1.
4.3.3
Loosen the pilot nut and remove the two screws retaining the pilot
assembly. Unscrew the thermocouple from the gas valve.
4.3.4
Re-assemble in reverse order, refit the burner heat shield then refit the
coals referring to section 3 for the correct coal layout. Refit the glass
panel and glass panel retaining trims. The fender and ash pan cover or
fascia can now be re-positioned.
29
