09
Installing a Reflector (or other Accessories or Modifiers)
Installing the Flash Tube
Preparing the XPLOR 600Pro
•
Note: To avoid damage, please detach the flash tube during the transportation.
1. Press down the
Reflector/Modifier Lock
Release lever.
3. Turn clockwise to lock it
into place.
2. Insert the reflector or any
Bowens mount light
modifier into the 3 tabs of
the Reflector/Modifier
Lock Release.
1. Remove the reflector or
other modifiers from
the flash head.
2. Align the 4 Flashtube pins to match the protruding
rings in the Tube Socket [4] surrounding the LED
Modeling Lamp [3] on the XPLOR body. Push the flash
tube in firmly until it is securely seated into the socket.
The flashtube can be handled without protective
gloves as the outer glass shields the actual flashtube.
Tilt Lock Handle
1. The Tilt Lock Handle locks
the angle of the flash tilt by
rotating the lever clockwise
and unlocks by rotating
counterclockwise, to allow
for positioning of the light.
2. The handle resting angle can be set to any degree by
pulling the handle away from the body, and freely
rotating it to your desired position. The handle
springs back to act as a locking lever when released.